Separators

• Ruffneck gas heater
• Gas detection

Dual 36” x 10’ – Vertical Test separator package- 1440 PSIG

**3 units available - 2 of which do not yet have the meter runs.  Additional $14K to add the meter run (per pkg).

• Alberta & BC registered.
• Vessel is RT-1 / 1/8” C.A. / PWHT.
• Sour service – fully flanged
• (2)  4” Sr. Meter run. – Daniel
• (2) BPCV - 3” – Fisher ET valve
   
• Both vessels are Dressed 3 phase.
• (4) LCV- 2” Fisher D4 – c/w 1 ¼” Tungsten trim
• (2) LIT – Rosemount 5302 Guide Wave Radar
• (4) Sur-flo – 2” x 1 ½” Turbines. c/w MC III Totalizer.                 
• Level switches – Rosemount 2120 Vibrating forks.
• PIT – Rosemount 2088 Transmitters
• WKM Ball valves
• Double doors.
• Exhaust fans

304L Internally Clad

RT-1, PWHT
c/w water boot.
Dressed 3 phase.
c/w Nu-flo liquid turbines, Norriseal LCV
HLSD – Kimray level switches
Rosemount Transmitters.
6” – Fisher -ET inlet control valve.
6” – sour meter run
c/w – (2) 4” bridals
methanol pump & tank
(2) Catadyne heaters
Fuel gas scrubber
12’ x 20’ – Building & skid.

Comes with condensate conditioner and fuel gas scrubber MDMT: -28 Celsius @ 9300 kPa MAWP: 9300 kPa @ 93 Celsius Test Pressure: 12,090 kPa CA: 3.2 mm Shell thickness: 53.35 mm  Shell material = SA 516 70N Decommissioned November 2010. Last inspections records available are from 2008. Ultrasonic Corrosion Mapping (AUT) was completed in 2010. Apoxy coating was applied in the areas where the internal coating was inadequate.

Please refer to supporting documents for additional info

3rd phase to be added (1-2 weeks to complete)

Principal Vessel Connections

• 6” 600# Inlet c/w 3” elbow diverter
• 6” 600# Gas out connection
• 2” 600# Water out connection
• 2” 600# Condensate out connection
• 2” 600# Drain connection
• 2 – 3” 600# LC connections
• 2” 600# PSV connection
• 3” 600# HLSD connection
• 3” 600# Inspection
• 4 – 2” 600# LG connections
• 2” 600# PI connection
• 2” 600# TI connection
• Internal float shield
• 6”x9#/cu. Ft. Demister pad

200BBL INTEGRAL INTERNALLY COATED TANK,

4"600# inlet, 3"600# outlet

Custom finish E&I to your spec (2-3 weeks)